How to configure your laptop to use ProLog Unleashed (Manual add)

These detailed documents will instruct you on how to configure your laptop computer using Windows XP Service Pack 2 to utilize the ProLog Unleashed service.
Please note that if you are not usng Windows XP Service Pack 2, you will need to consult the documentation or manufacturer of your wireless networking equipment for configuration instructions.
1.	Click on "Start" and then click on "Control Panel."
2.	Next, click on "Network and Internet Connections."
3.	Click on "Network Connections" near the bottom of the window.
4.	If your wireless network card is properly installed, you will see a wireless network adapter listed. If you do not see your wireless adapter, your wireless network card is not being properly detected. Please contact your computer manufacturer or network card vendor for assistance. Right click on the wireless network adapter and click on "Properties."
5.	Next, click on the "Wireless Networks" tab.
6.	Place a checkmark in the box next to "Use Windows to configure my wireless network settings."
7.	Next, click on the "Add" button under "Preferred Networks."
8.	Under "Network name (SSID)," type "ProLogUnleashed-Public-Internet" (this is case sensitive). Under "Wireless network key," make sure "Network authentication" is set to "Open," and "Data encryption" is set to "Disabled." Click "OK."
9.	You should now see "ProLogUnleashed-Public-Internet" under "Preferred networks." Click on the "View Wireless Networks" button under "Available networks."
10.	The "Wireless Network Connection" window will open. Click on the "ProLogUnleashed-Public-Internet" network and then click on the "Connect" button in the bottom right corner of the window.
11.	Once connected, you are now ready to sign up or use the ProLog Unleashed service. For login instructions, CLICK HERE.